![]() So as to eliminate confusion, I went ahead and soldered each pair as I matched them so I wouldn't forget. I then knew these 2 should be soldered together. I plugged the female end of my usb cable into my already completed male end, and while holding 1 meter lead on an exposed wire from my female connector, touched each of my colored Cat-5 wires in turn until it made a noise. They will either make a noise, or if that feature is not on your meter, make the needle jump or numbers go crazy, indicating a closed circuit. ![]() You can test this by touching the 2 leads of your meter together. Using a meter, set it to the Ohm (greek Omega character) setting, ideally the setting that sounds on connection. To do this, I used the electrical trick called "ohming out the line". Before you can finish out the other side, you have to make sure you are connecting the right wires in sequence.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |